随机腐蚀缺陷对油管破裂强度的影响
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

TE38

基金项目:

国家科技重大专项“高效智能采油采气工程关键技术及装备”(编号:2024ZD1406500);国家自然科学基金重点项目“复杂结构‘井工厂’立体设计建设基础研究”(编号:52234002)


Effect of random corrosion defects on burst strength of tubing
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    腐蚀是油管遭受损伤的常见破坏形式,其中点蚀由于其隐蔽性和随机性,引发了许多突发事故。为此,针对当前点蚀随机分布特性对油管破裂强度的影响认识不清问题,基于点蚀缺陷的特征参数,采用非线性有限元法,建立了油管内壁点蚀随机分布的三维数值模型,并利用全尺寸腐蚀管道的破裂实验数据验证了模型的可靠性。随后,考虑均匀凹坑和组合凹坑两种随机腐蚀条件,系统研究了凹坑的分布状态、相对腐蚀深度、间距和密度对破裂强度的影响。最后,基于多元回归分析方法提出了含随机点蚀缺陷的油管破裂强度预测公式。研究结果表明:与以往含规则点蚀缺陷的油管相比,油管在随机点蚀条件下的破裂强度降低更为显著,约为12.5%;缺陷参数对油管破裂强度具有阈值效应,当腐蚀密度大于0.04,破裂强度的下降速率将减缓;在多点随机腐蚀条件下,均匀凹坑与组合凹坑对破裂强度的影响相近,主要取决于最大凹坑的大小;所提出的经验公式能够准确评估破裂强度,与有限元结果相比,相对误差为2.4%。结论认为,该认识揭示了随机分布条件下的点蚀缺陷参数与破裂强度的相关性,可为管柱腐蚀缺陷检测以及强度预测提供理论依据和工程指导。

    Abstract:

    Corrosion represents a common form of damage in tubing, with pitting corrosion often leading to unexpected failures due to its concealed and random nature. In order to clarify the effect of randomly distributed pitting defects on tubing burst strength, a three-dimensional numerical model of inner-wall pits was established using nonlinear finite element analysis, based on characteristic pitting parameters. The reliability of the model was verified against full?scale burst test data of corroded pipes. Two random corrosion patterns, including uniform pits and combined pits, were considered to systematically study the influence of pit distribution, relative corrosion depth, spacing, and density on burst strength. An empirical formula for predicting the burst strength of randomly pitted tubing was subsequently developed through multiple regression analysis. The results show that, compared with tubing containing regularly arranged pits, randomly pitted tubing exhibits a more significant reduction in burst strength, by approximately 12.5%. A threshold effect of defect parameters is observed, where burst strength decreases rapidly when the corrosion density falls below 0.04. Under multi?pit random corrosion conditions, both uniform and combined pits affect burst strength in a similar manner, which is primarily controlled by the size of the largest pit. The proposed prediction formula shows good agreement with finite element results, with an average relative error of 2.4%. It is concluded that the correlation between pitting defect parameters and burst strength under random distribution conditions has been quantitatively established, which provides a theoretical basis and practical guidance for the integrity assessment and residual strength prediction of corroded tubing.

    参考文献
    相似文献
    引证文献
引用本文

王捷力,来轩昂,董雪林,等. 随机腐蚀缺陷对油管破裂强度的影响[J]. 科学技术与工程, 2026, 26(29): 12567-12575.
Wang Jieli, Lai Xuanang, Dong Xuelin, et al. Effect of random corrosion defects on burst strength of tubing[J]. Science Technology and Engineering,2026,26(29):12567-12575.

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2026-01-19
  • 最后修改日期:2026-03-17
  • 录用日期:2026-03-25
  • 在线发布日期: 2026-10-28
  • 出版日期:
×
关于《科学技术与工程》全新官方网站正式上线的通知公告
关于抵制伪造参考文献学术不端行为的声明
关于规范使用生成式人工智能的声明
亟待确认版面费归属稿件,敬请作者关注